Maytag MHWC7500YW Owner's Manual

q

  Check electrical requirements. Be sure you have correct  

electrical supply and recommended grounding method.

q

  Check that all parts are now installed. If there is an extra 

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Check that transport materials were completely  

removed from back of washer.

q

  Check that both hot and cold hoses are attached and water 

faucets are on.

q

  Check for leaks around faucets, valves, and inlet hoses.

q

  Remove protective film from console and any tape  

remaining on washer.

q

  Check that washer is plugged into a grounded  

3-prong outlet.

q

  Dispose of/recycle all packaging materials.

q

  Read “Using Your Washer.”

q

  To test and clean your washer, turn on the washer and 

choose the Normal cycle and run it without clothes. Use only 

HE detergent. Use 1/2 the manufacturer’s recommended 

amount for a medium-size load. 

If washer is not level, use a 1/2" or 13 mm open-end or  

adjustable wrench to turn jam nuts clockwise on feet until they 

are about 1/2" (13 mm) from the washer cabinet. Then turn the 

leveling foot clockwise to lower the washer or counterclockwise 

to raise the washer. Recheck levelness of washer and that all 

four feet are firmly in contact with the floor. Repeat as needed.

HELPFUL TIP: You may want to prop up front of washer 

about 4" (102 mm) with a wood block or similar object that  

will support weight of washer.

When washer is level and all four feet are firmly in contact 

with the floor, use a 15/32" or 12 mm open-end or adjustable 

wrench to turn jam nuts counterclockwise on leveling feet 

tightly against washer cabinet. 
HELPFUL TIP: You may want to prop washer with  

wooden block.

Jam nut

Jam nut