Hotpoint RA724KWH Owner's Manual

″ and 24″ Compact

— Save these

instructions for local inspector’s use.

— Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these

instructions for future reference.

• Skill level – Installation of this appliance

requires basic mechanical skills.

• Completion time – 1 to 3 hours

• Proper installation is the responsibility of

the installer. 

• Product failure due to improper installation

is not covered under the Warranty.

— This appliance must

be properly grounded.

All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).

To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can 
be reduced by installing a range hood that
sticks out at least 5” beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13”

.

Be sure your appliance is properly installed
and grounded by a qualified technician.

Make sure the cabinets and wall coverings
around the range can withstand the temperatures
(up to 200°F) generated by the range.

— Before beginning the

installation, switch power off at service panel
and lock the service disconnecting means to
prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag, to
the service panel.

— To reduce the risk 

of tipping, the appliance must be secured by
properly installed Anti-Tip device packed with
this appliance.

If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.

If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
device is engaged when the range is pushed
back against the wall.