KitchenAid KSEG700ESS-SS Installation Guide

1. Remove shipping materials, tape and film from the range. 

Keep cardboard bottom under range. Do not dispose of 
anything until the installation is complete.

2. Remove oven racks and parts package from oven and 

shipping materials.

3. To remove cardboard bottom, first take 4 cardboard corners 

from the carton. Stack one cardboard corner on top of 
another. Repeat with the other 2 corners. Place them 
lengthwise on the floor behind the range to support the range 
when it is laid on its back.

4. Using 2 or more people, firmly grasp the range and gently lay 

it on its back on the cardboard corners.

5. Remove cardboard bottom.

The leveling legs can be adjusted while the range is on its back. 
See the “Adjust Leveling Legs” section.

NOTE: To place range back up into a standing position, put a 
sheet of cardboard or hardboard on the floor in front of range to 
protect the flooring. Using 2 or more people, stand range back up 
onto the cardboard or hardboard.

1. Remove the anti-tip bracket from the inside of the oven.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall 
mounting method. If you are installing the range in a mobile 
home, you must secure the range to the floor.

This anti-tip bracket and screws can be used with wood or 
metal studs.

3. Determine and mark centerline of the cutout space. The 

mounting bracket can be installed on either the left-hand or 
right-hand side of the cutout. Position mounting bracket 
against the wall in the cutout so that the V-notch of the 
bracket is 12½" (31.8 cm) from centerline as shown.

Centerline

A

B