KitchenAid KSM85PBMY Use & Care Manual

To Operate Speed Control
Speed control lever should always be 
set on lowest speed for starting, then 
gradually moved to desired higher 
speed to avoid splashing ingredients 
out of bowl. See page 15 for Speed 
Control Guide.

To Lock Motor Head
 

  Make sure motor head is 

completely down.

 

  Place locking lever in LOCK 

position.

 

  Before mixing, test lock by 

attempting to raise head.

To Unlock Motor Head
 

  Place lever in UNLOCK position.

NOTE: Motor head should always be 
kept in LOCK position when using mixer.

ASSEMBLING YOUR TILT-HEAD STAND MIXER

To Attach Pouring Shield
 

  Turn speed control to OFF.

 

  Unplug Stand Mixer or 

disconnect power.

 

  Attach Flat Beater, Dough Hook, 

or Wire Whip and bowl (see 
page 11).

 

  From the front of the mixer, slide 

the Pouring Shield over the bowl 
until the shield is centered. The 
bottom rim of the shield should fit 
within the bowl.

To Remove Pouring Shield
 

  Turn speed control to OFF.

 

  Unplug Stand Mixer or 

disconnect power.

 

  Lift the front of the Pouring Shield 

clear of the bowl rim and 
pull forward. 

 

  Remove attachment and bowl.

To Use Pouring Shield
 

  For best results, rotate the shield 

so the motor head covers the “u” 
shaped gap in the shield. The 
pouring chute will be just to the 
right of the attachment hub as you 
face the mixer. 

 

  Pour the ingredients into the bowl 

through the pouring chute. 

USING YOUR POURING SHIELD*

* If Pouring Shield is included.

001-019PIL1348700   Sec1:12

10/2/07   8:29:50 AM