Siemens WLAN Repeater 108 S30853-H1030-R701 User Manual

Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-3x-7619 / security_config.fm / 06.11.2008

Te

m

plat

e 20

05_0

5_02

ì

To go to the next step in the Security Setup Wizard, click on Next >.

This screen only appears in Repeater or access point Operating Mode.
This step allows you to determine which PCs should have wireless access to the 
Gigaset WLAN Repeater 108. The access control is based on the 

 of the PCs' 

network adapters. You can enter the MAC addresses for the PCs manually or select them 
from the list of PCs that are currently logged in.

The default setting for access control is disabled. This means that all PCs using the 
correct 

 and the correct encryption can log in.

ì

Next to MAC address filter select the option On to activate the MAC filtering.

Please note:
u If you have reset the encryption, it is very important that you make a note of 

the key or the passphrases. You will need this information to configure the 
wireless network adapters properly. 

u When you have completed the Security Setup Wizard, you must also set the 

WEP encryption in other components of your wireless network.

Note:
The access control setting is only valid for wireless access of PCs to the repeater or 
access point. If you use a router in your wireless network and have configured access 
control there for PCs, you must also set this access control on the repeater.