Whirlpool UXT4036ADW Installation Instruction

5. Mark Hole Locations 

Lift the range hood into place and insert the mounting bracket 
tabs through the slots in the back of the range hood. 

Hold the range hood firmly in place with one hand and bend each 
mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

6. Drill Electrical Opening

Using a 1

¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked 

previously at the electrical strain relief.

OPTIONAL: Using a 

¹⁄₈" (3 mm) drill bit, drill pilot holes for the 

dots marked previously at each mounting tab at an approximate 
45° angle in an upward direction.

7. Prepare Range Hood Vents and 

Mounting Tabs

■

Install a UL Listed/CSA Approved 

¹⁄₂" (13 mm) strain relief (A).

■

Start a #8-18 x 

⁵⁄₈" (4.2 x 16 mm) truss-head screw into the 

mounting tab (C) on each side of the range hood as shown in 
the inset. Insert the screws approximately 2 turns into the 
mounting tab holes.

■

Remove the (2) T10

®†

 Torx

®

 screws and remove the top, front 

rectangular vent cover (B).

B

A

A

B

C

†®TORX and T10 are registered trademarks of Acument Intellectual Properties, LLC.