Whirlpool WDF760SADM Owner's Manual

 

Dries dishes with heat. This option, with the use of 
rinse aid, will provide the best drying performance. 
Plastic items are less likely to deform when loaded in 
the top rack. Use Heat Dry for optimum dry 
performance, Turn the Heat Dry option off for air dry.

Uses heating 
element to speed 
drying times. 
Heat Dry option 
defaults to On 
when any cycle is 
selected except 
for 1-Hour Wash. 

Runs dishwasher at a later time. Select a wash cycle 
and options. Each time you press the delay button it 
will display the next available delay time. Press 
DELAY. Press START/RESUME. Close door firmly. 

NOTE: The dishwasher remembers the last Delay 
you selected. To reset the delay time to something 
other than what is displayed, continue to press the 
Delay button until the desired delay time is reached.

NOTE: Anytime the door is opened (such as, to add 
a dish); START/RESUME must be pressed again to 
resume delay countdown. 

Delays start of a 
cycle up to 
24 hours

.

Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle. 

To turn on Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Control Lock 
light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your 
dishwasher is locked, light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked.

To turn off Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Light turns off.

NOTE: If your model requires you to press and hold DELAY to lock controls, Control Locked LED will be on or off to indicate 
whether Control Lock is active or not.

Press to start or resume a wash cycle.

If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle will 
not resume until door is closed and START/RESUME is pressed.

NOTE: If Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing 
START/RESUME. If door is not closed within 3 seconds, Start/Resume button LED will flash, an audible tone will 
be heard (on some top control models), and cycle will not start.

Press to cancel wash cycle.

Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. Press 
and hold START/RESUME for 3 seconds.

To follow progress of 
your dishwasher cycle.
NOTE: Indicators shown 
are not available on all 
models.

The Clean indicator glows when a cycle is finished. 

If you select Sani Rinse option, when cycle is finished, the “Sanitized” indicator glows. 
If your dishwasher did not properly sanitize your dishes, the light flashes at the end of 
the cycle. This can happen if the cycle is interrupted, or water could not be heated to 
required temperature. The light goes off when you open and close door or press 
CANCEL.