Yamaha YSP-2500 Owner's Manual
PREPARATIONS
➤ Initial settings
En
36
❑
If an error message is displayed
If an error message is displayed on the TV screen, see “Error messages” below to determine the cause and resolve the problem. Follow the instructions displayed on the TV screen
to begin measurement again.
to begin measurement again.
Error messages
Error message
Cause
Remedy
ERROR E-1
Please test in quieter environment.
There is too much noise in your listening room.
Make sure that your listening room is as quiet as possible. You
may want to choose certain hours during the day when there
is not much noise coming from outside.
may want to choose certain hours during the day when there
is not much noise coming from outside.
ERROR E-2
No MIC detected. Please check MIC connection and re-try.
The IntelliBeam microphone is disconnected.
Connect the IntelliBeam microphone to the INTELLIBEAM
MIC jack on the front of this unit and begin measurement
again.
MIC jack on the front of this unit and begin measurement
again.
ERROR E-3
Unexpected control is detected. Please re-try.
Some other operations were performed on this unit.
Begin measurement again. Do not perform any other
operations with this unit during measurement.
operations with this unit during measurement.
ERROR E-4
Please check MIC position. MIC should be set in front of
Sound Projector. Please re-try.
Sound Projector. Please re-try.
The IntelliBeam microphone is not placed in front of this unit.
Position the IntelliBeam microphone in front of this unit and
begin measurement again.
begin measurement again.
ERROR E-5
Please check MIC position. MIC should be set above 1.8m/
6.0ft and re-try.
6.0ft and re-try.
The IntelliBeam microphone is not placed in the right distance
from this unit.
from this unit.
Position the IntelliBeam microphone at a distance of more
than 1.8 m (6.0 ft) from this unit and begin measurement
again.
than 1.8 m (6.0 ft) from this unit and begin measurement
again.
ERROR E-6
Volume level is lower than expected. Please check MIC
position/connection and re-try.
position/connection and re-try.
The IntelliBeam microphone cannot collect the sound
produced by this unit.
produced by this unit.
Position the IntelliBeam microphone properly, check the
connection, and then begin measurement again.
connection, and then begin measurement again.
ERROR E-7
Unexpected error happened. Please turn off and re-try.
An internal system error occurred.
Press the z key to turn off this unit, then run AUTO SETUP
procedure again after turning this unit on.
procedure again after turning this unit on.
ERROR E-8
Headphones are connected. Please unplug the
headphones and re-try.
headphones and re-try.
Headphones are connected.
Unplug the headphones and begin measurement again.
ERROR E-9
Please check the connection with subwoofer.
The subwoofer is not connected properly.
Be sure the subwoofer is properly connected (p. 29) and
configure the “WIRELESS FUNCTION” of “SUBWOOFER” in
the setup menu (p. 56).
configure the “WIRELESS FUNCTION” of “SUBWOOFER” in
the setup menu (p. 56).