AT&T CL82313 Quick Setup Guide

Battery installation
Install the battery as shown below. Charge your handset(s) before initial use. 

The battery is fully charged after ten hours of continuous charging.

CL82113/CL82213/CL82263/CL82313/CL82363/
CL82413/CL82463

Use only the supplied rechargeable battery or replacement battery (model 

BT183342

).

Caution: Use only the power adapter(s) provided with this product. To obtain a replacement,  
visit our website at 

 or call 

.  

In Canada, dial 

.

Quick reference guide - handset 

Step 1
Plug the battery connector 
securely into the socket 
inside the handset battery 
compartment. Insert the 
supplied battery with the 
label 

THIS SIDE UP facing 

up as indicated.

Step 2
Align the cover flat 
against the battery 
compartment, then 
slide it upwards until it 
clicks into place.

Step 3
Charge the handset by placing it face forward in 
the telephone base or charger. The 

CHARGE light 

on the handset is on during charging.

Press to initiate a one-to-one or  

one-to-group broadcast.
Press and hold to broadcast to a group of 

system handsets.

•

•

Quick reference guide - telephone base

Raise the 
antenna.

Route the power 
adapter cord 
through this slot.

Plug the large end 
of the telephone 
base power 
adapter into a 
power outlet not 
controlled by a 
wall switch.

Plug one end of 
the telephone 
line cord into a 
telephone jack 
or a DSL filter.

If you have DSL 
high-speed Internet 
service, a DSL filter 
(not included) is 
required.

Route the  
telephone line cord 
through this slot.

CHARGE light

On when the handset is 

charging in the telephone base 

or charger. 

Press repeatedly to view the 

last ten numbers dialed.
While entering numbers,  

press and hold to insert a 

dialing pause.

•

•

qCID/VOLUME

Press q

CID to show caller 

ID log when the handset is 

not in use.
Press to scroll down while 

in menus.
Press to decrease the 

listening volume when on 

a call.

•

•

•

Press to make or answer a 

call.

•

Press and hold to set or dial 

your voicemail number.

•

Press to switch to tone 

dialing temporarily during 

a call if you have pulse 

service.
While entering names, press 

to change the next letter to 

upper or lower case.

•

•

Press to make or answer a 

call using the speakerphone.

•

pDIR/VOLUME

Press p

DIR to show 

directory entries when the 

handset is not in use.
Press to scroll up while in 

menus. 
Press to increase the 

listening volume when on 

a call.

•

•

•

When the handset is not 

in use, press to show the 

menu. 
While in the menu, press to 

select an item or save an 

entry or setting.

•

•

During a call, press to hang 

up.
While in a menu, press to 

cancel an operation, back 

up to the previous menu, 

or exit the menu display, or 

press and hold this button 

to exit to idle mode.

•

•

Press and hold to enter the 

QUIET mode setting screen, 

or to deactivate 

QUIET 

mode.

•

During a call, press to mute 

the microphone.
Press to delete digit or 

character.

•

•

During an outside call, 

intercom call, message or 

announcement playback, press 

to change the audio quality to 

best suit your hearing. 

Plug the power adapter 
into a power outlet not 
controlled by a wall 
switch.

Plug the other end 
of the telephone 
line cord into the 
telephone jack on the 
back of the telephone 
base.

Plug the small end of the telephone base 
power adapter into the power adapter 
jack on the back of the telephone base.

On when the handset is in use, 

or when the answering system is 

answering an incoming call.
Flashes when another 

telephone is in use on the 

same line.

•

•

Press to skip a message.

REPEAT 

Press to repeat a 

message.
Press twice to 

play the previous 

message.

•

•

Press to turn the built-in 
answering system on or off.

Shows the number of messages or other answering 
system information.

While the phone is idle,  
press to page all handsets.

Press to start or stop message 
playback.

qVOL- and pVOL+

During message playback, 

press to adjust the listening 

volume.
While in idle mode, press to 

adjust the base ringer volume.

•

•

Press to delete the message 

currently playing.
Press twice to delete all old 

messages when the phone is 

not in use.

•

•