Alpine INE-W940 Owner's Manual
48
-EN
Camera Setup Operation
With an optional camera connected, its video is output to the monitor.
When the camera is connected, set this item.
When the camera is connected, set this item.
1
Touch [Setup] icon of Top banner.
The Setup main screen is displayed.
2
Touch [
(CAMERA)].
The Camera Setup screen appears.
3
Select the desired item.
Setting items: Camera / Camera Interrupt (Power OFF Mode)
4
Touch [
] or [
] etc., to change its setting.
• When the pop-up window for setup is displayed, touch [
] to
close the window after setting.
5
Touch [
] to return to the previous screen.
• Immediately after changing the Camera Setup (while the system is
writing data automatically) do not turn the ignition key to OFF.
Otherwise, the settings may not be changed.
Otherwise, the settings may not be changed.
AUX Camera Setting
[Camera] is selected on the Camera setup menu in step 3.
Refer to “Camera Setup Operation” (page 48).
Refer to “Camera Setup Operation” (page 48).
Setting item: Camera Select / Camera Signal */ Guide
Adjustment *
Setting contents: Off / Rear (Initial setting)
* If “Camera Select” is set to “Off,” this option is not available.
Setting the AUX Camera Signal Input
When the AUX camera is connected, the video input signal type can be
chosen.
chosen.
Setting item: Camera Signal
Setting contents: AUTO (Initial setting) / NTSC / PAL
Setting contents: AUTO (Initial setting) / NTSC / PAL
Adjusting the Rear Camera Guide
If you select “Rear” you can adjust the camera guide position.
Setting item: Guide Adjustment
1
Touch [Guide Adjustment].
The camera guide adjustment screen is displayed.
2
Touch [Adjust].
• If [Adjust] does not appear, proceed to step 3.
3
Touch the guide you intend to adjust.
Guide line can also be selected by touching [
] [
].
4
Touch [
], [
], [
] or [
] to adjust the position
of the guide.
• Touching [Clear] clears adjustments and returns to the setting
before guide line alteration.
5
After the adjustment is completed, touch [Set].
Camera Setup
To display the Camera Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Camera mode operation has
been released. Engaging the parking brake can reactivate the
Camera Setup Menu, as long as the car’s ignition has not been
turned off. It is not necessary to repeat the above procedure
(1 through 3) of “To display the Camera mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the Camera mode screen.”
been released. Engaging the parking brake can reactivate the
Camera Setup Menu, as long as the car’s ignition has not been
turned off. It is not necessary to repeat the above procedure
(1 through 3) of “To display the Camera mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the Camera mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of Camera Setup. Refer to each section for
details.
“Setting item” of Camera Setup. Refer to each section for
details.
Setting the Camera Input
NTSC/PAL: Choose the video input signal type manually.
AUTO:
The suitable video input signal type will be
automatically chosen between NTSC and PAL.
automatically chosen between NTSC and PAL.