Sony XBR-55X850B Owner's Manual

D:\SONY TV\SY140104_Clover 67 (Rev-1)\4533569121_US\US03STU.fm

XBR-70X850B / 65X850B / 55X850B / 49X850B / KDL-70X830B / 65X830B / 55X830B

4-533-569-12(1)

US

Consider the following measures when 
securing your TV to a Stand (not supplied).

Secure the Stand for the TV.
Make sure the Stand can adequately 
support the weight of the TV. Use two 
angle braces (not supplied) to secure 
the stand. For each angle brace use the 
appropriate hardware to:
• Attach one side of the angle brace to 

the wall stud.

• Attach the other side to the Stand.

Secure the TV to the Stand.
Use the optional hardware listed as 
follows (not supplied):
• M4 machine screw (screwed into the 

TV’s rear cover)

• A screw or similar (attach it to the 

Stand)

• Rope or chain (strong enough to 

support the weight of the TV). Make 
sure that there is no excess slack in 
the rope or chain.

The length of the M4 machine screw 
differs depending on the rope or chain 
diameter. Please see below illustration.

Anchor the TV to the wall by using bolts, 
wall anchor and chain (or rope).

~
• Your TV is shipped with screws attached 

to the rear of the TV depending on the TV 
model. (They are fastened in the screw 
holes for wall mounting.) Be sure to 
remove the upper two screws prior to 
anchoring the TV to a wall.

• Securing the TV to the stand without 

securing the TV and the stand to the wall 
provides minimum protection against the 
TV toppling over. For further protection, 
be sure to follow the three measures 
recommended.

Stand

Angle brace 
(not supplied)

Screw hole on 
the rear cover

M4 
machine 
screw (not 
supplied)

Rope or chain 
(not supplied)

Screw
(not supplied)

Screw M4

Rope or chain

TV’s rear cover

8-12 mm

Anchor bolts (M6) (not supplied)

Wall-
mount 
holes

Rope or 
chain (not 
supplied)

Wall-anchor 
(not 
supplied)