Sony XBR43X830C Owner's Manual

Page of 60
3
US
US
FCC Related Information
This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and 
can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause 
harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or 
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and 
receiver.
• Connect the equipment into an outlet on a circuit 
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician 
for help.
Safety and Regulatory
This device complies with Industry Canada licence-exempt 
RSS standard(s). Operation is subject to the following two 
conditions: (1) this device may not cause interference, and 
(2) this device must accept any interference, including 
interference that may cause undesired operation of the 
device.
To prevent radio interference to the licensed service, this 
device is intended to be operated indoors and away from 
windows to provide maximum shielding. Equipment (or its 
transmit antenna) that is installed outdoors is subject to 
licensing.
Only use Wireless LAN indoors when using it with IEEE 
802.11a (5 GHz).
This equipment complies with FCC/IC radiation exposure 
limits set forth for uncontrolled equipment and meets the 
FCC radio frequency (RF) Exposure Guidelines in 
Supplement C to OET65 and RSS-102 of the IC radio 
frequency (RF) Exposure rules. This equipment has very low 
levels of RF energy that it deemed to comply without 
maximum permissive exposure evaluation (MPE). But it is 
desirable that it should be installed and operated with at 
least 20 cm and more between the radiator and person’s 
body (excluding extremities: hands, wrists, feet and 
ankles).
This device and its antenna(s) must not be co-located or 
operating with any other antenna or transmitter except 
Grant condition.
Note
This television includes a QAM demodulator which should 
allow you to receive unscrambled digital cable television 
programming via subscription service to a cable service 
provider. Availability of digital cable television 
programming in your area depends on the type of 
programming and signal provided by your cable service 
provider.
Before setting up your TV
Some TV models are packaged with a detached Table-Top 
Stand so you can mount your TV to a wall right away. See 
page 21 (Installing the TV to the Wall) if you want to mount 
the TV to a wall. If you are not mounting the TV to a wall, 
you will need to attach the Table-Top Stand. You will need a
Phillips screwdriver (not supplied) and the supplied screws 
to complete the task. Look for the supplied Table-Top Stand 
instruction leaflet.
Be sure to consider the following while setting up your TV: 
• Disconnect all cables when carrying the TV. 
• Carry the TV with the adequate number of people; larger 
size TVs require two or more people.
• Correct hand placement while carrying the TV is very 
important for safety and to avoid damage.
• Ensure your TV has adequate ventilation, see page 23.
• For best picture quality, do not expose the screen to direct 
illumination or sunlight. 
• Avoid installing the TV in a room with reflective wall and 
floor materials. 
• Avoid moving the TV from a cold area to a warm area. 
Sudden room temperature changes may cause moisture 
condensation. This may cause the TV to show poor 
picture and/or poor color. Should this occur, allow 
moisture to evaporate completely before powering the TV 
on.
Securing the TV
Sony strongly recommends taking 
measures to prevent the TV from 
toppling over.
Unsecured TVs may topple and result 
in property damage, serious bodily 
injury or even death.
Preventing the TV from Toppling
• Secure the TV to a wall and/or stand.
• Do not allow children to play or climb on furniture and TV 
sets.
• Avoid placing or hanging items on the TV.
• Never install the TV on:
 slippery, unstable and/or uneven surfaces.
 furniture that can easily be used as steps, such as a 
chest of drawers.
• Install the TV where it cannot be pulled, pushed, or 
knocked over.
• Route all AC power cords and connecting cables so that 
they are not accessible to curious children.
Safety information
Declaration of Conformity
Trade Name: SONY
Model: XBR-75X850C/XBR-65X890C/XBR-65X850C/
XBR-55X890C/XBR-55X850C/XBR-49X830C/XBR-
43X830C
Responsible Party: Sony Electronics Inc.
Address: 16530 Via Esprillo,
San Diego, CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part 15 of the FCC rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, 
including interference that may cause undesired 
operation.
Pursuant to FCC regulations, you are cautioned that any 
changes or modifications not expressly approved in this 
manual could void your authority to operate this 
equipment.