Lorex LNC116 Owner's Manual
4
Getting Started
3. A: Connect an Ethernet cable (included) to the NET port on the camera and connect
the other end to an available LAN port (usually numbered 1~4) on your router (not
included). The blue Network LED on the camera will glow blue when the camera is
connected to your network.
included). The blue Network LED on the camera will glow blue when the camera is
connected to your network.
• OR:
B: If your router supports WPS, press and hold the WPS button on your router until the
WPS light turns on. Then, press the WPS button on the camera within 1 minute. The
camera will automatically connect to your WiFi network and the blue Network LED on
the camera will turn on.
WPS light turns on. Then, press the WPS button on the camera within 1 minute. The
camera will automatically connect to your WiFi network and the blue Network LED on
the camera will turn on.
NOTE: Not all routers support WPS, and the location of the WPS button on your router
depends on your router model. Check your router’s instruction manual for details, or see
“WiFi Setup” on page 18 for instructions on manually setting your camera up for WiFi.
depends on your router model. Check your router’s instruction manual for details, or see
“WiFi Setup” on page 18 for instructions on manually setting your camera up for WiFi.
3A
Router
Ethernet Cable
3B
Press and hold the WPS button
on the router
on the router
Then, press the WPS button
on the camera
on the camera