Lorex LNC226X Owner's Manual
DRAFT
21.2.2
WiFi Security (Configuring WiFi settings)
Configure the camera to connect to a WiFi network and configure WiFi settings.
To configure WiFi Settings:
Note
For instructions on connecting your camera to a WiFi network, see 13.2 PC WiFi Setup, page 38 or 14.2
Mac WiFi Setup, page 44.
For instructions on connecting your camera to a WiFi network, see 13.2 PC WiFi Setup, page 38 or 14.2
Mac WiFi Setup, page 44.
1. Perform one of the following:
• To Scan available WiFi networks, click WiFi Scan.
• To connect to a hidden WiFi network, select Enable Wifi function, and manually fill
• To connect to a hidden WiFi network, select Enable Wifi function, and manually fill
out the SSID, Security mode (i.e. encryption type), and the WEP or WPA-PSK Key.
Click Save & Apply. Refresh the page and select WiFi test. When the test is suc-
cessful, disconnect the camera from Ethernet.
Click Save & Apply. Refresh the page and select WiFi test. When the test is suc-
cessful, disconnect the camera from Ethernet.
• To configure a fixed IP address for the camera when connected over WiFi, click IP
address, configure the settings as needed, and click Save & Apply.
• To test configured WiFi settings, click WiFi test.
21.3
Video
Configure camera video and streaming settings.
21.3.1
Video Settings
Adjust the video quality settings. Set the password to access camera video through L-View
or apps.
or apps.
To set the camera password for accessing video through L-View or apps:
1. Under Password (play video), enter a password to access the camera video using L-
View or smart phone and tablet apps.
2. Click Save & Apply to save the new password.
#LX400003; r. 1.0/12783/13451; en-US
151