Summit 108-Bottle Dual Zone Built-In Wine Cellar User Manual
7
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not
use an extension cord with this appliance. However, if you must use an extension cord it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding
type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.
REVERSING THE DOOR SWING OF YOUR APPLIANCE
This unit has the capability of the door opening from either the left or right side. The unit is delivered to
you with the door opening from the left side. Should you desire to reverse the opening direction, follow
the following reversal instructions.
1. Lock Screws
2. Lower Door Hinge
3. Door Shaft Assembly
4. Center Hinge
5. Door Axle
NOTE: All parts removed must be saved to allow the door swing to be reversed.
1. Open the lower glass door and remove the two lock screws (1) holding the door shaft assembly (3) to
1. Open the lower glass door and remove the two lock screws (1) holding the door shaft assembly (3) to
the lower glass door. Be careful to hold the glass door firmly after removing the screws. (Fig. 1)
2. Pull down to remove the lower glass door and place it on a padded surface to prevent scratching it.