Summit Freestanding Commercial Kegerator - Black User Manual
9
d) Place the CO
2
tank and CO
2
regulator valve component into the
cabinet and fix the CO
cabinet and fix the CO
2
tank
with tank bracket and bolt (See
Figure 8).
Figure 8).
4. Install the beer keg:
Place the beer keg into the cabinet and
firmly connect the keg’s opening to the
connection port of the mixed ball valve
(See Figure 10).
firmly connect the keg’s opening to the
connection port of the mixed ball valve
(See Figure 10).
Note: To place a keg into the cabinet,
use the keg handle to move the keg
to the front of the open beer
dispenser, then carefully tip the keg
so that the raised bottom edge contacts the edge of the cabinet. Finally, lift
the keg handle to raise the keg to the level of the floor of the cabinet and
push the keg into place.
to the front of the open beer
dispenser, then carefully tip the keg
so that the raised bottom edge contacts the edge of the cabinet. Finally, lift
the keg handle to raise the keg to the level of the floor of the cabinet and
push the keg into place.
5. Install tap handle and beer tap:
Screw the tap handle clockwise into the beer tap to make a firm connection.
Then connect the tap to the beer tower components and tighten with a wrench
(See Figure 9).
Then connect the tap to the beer tower components and tighten with a wrench
(See Figure 9).
6. Install upper cover guardrail and drip tray:
Set the upper cover guardrail and drip tray on top of the beer dispenser (See
Figure 10).
Figure 10).
Notes:
• When replacing the beer keg, first turn off the safety switch on the CO
2
regulator valve and remove the mixed ball valve to take out the keg.
• When replacing the CO
2
gas cylinder, remember to turn off the main
switch of the CO
2
gas cylinder and the safety switch on the CO
2
regulator
valve. Afterwards, use a wrench to loosen the hexagonal nut port
connecting the CO
connecting the CO
2
regulator valve with the CO
2
tank. Then, using a
wrench, remove the fixed bolt of the CO
2
tank to take out the CO
2
tank.
• During the installation process, be sure that all parts are connected tightly
and that there are no gas leaks.
• When connecting the hose to the connection port, you can dip the ends
into warm water to make the connection easier.
• If the high-pressure compressed gas in the CO
2
tank is not handled
properly, it could be dangerous:
a. Make a note of the D.O.T. testing date on the cylinder neck before
a. Make a note of the D.O.T. testing date on the cylinder neck before
installation. If it is more than 5 years old, don’t use the product. Return
it to the gas supplier.
it to the gas supplier.
b. Keep gas cylinder away from heat sources. Unused cylinders should
be placed upright in a cool, ventilated place (preferably at 70
°F).