Summit 5.5 cf Glass Door All Refrigerator - White User Manual

Page of 16
 
responsibility and obligation to have it replaced with a properly grounded 3-prong wall 
outlet. 
To prevent accidental injury, the cord should be secured behind the unit and not left 
exposed or dangling. 
The unit should always be plugged into its own individual electrical outlet which has a 
voltage rating that matches the rating label on the appliance. This provides the best 
performance and also prevents overloading house wiring circuits that could cause a fire 
hazard from overheated wires. Never unplug the unit by pulling on the power cord. 
Always grip the plug firmly and pull straight out from the receptacle. Repair or replace 
immediately any power cord that has become frayed or otherwise damaged. Do not use 
a cord that shows cracks or abrasion damage along its length or at either end. When 
moving the unit, be careful not to damage the power cord. 
 
Extension Cord
Do not use an extension cord with this appliance. If the power cord is too short, have a 
qualified electrician or service technician install an outlet near the appliance.
 
 
Reversing the Door Swing
If you find the direction of opening the door of the appliance inconvenient, you can 
change it.  Holes on the opposite side have already been prepared at the factory. 
This appliance can be opened from either the right side or the left. By default, the door 
hinge is on the right side. If you prefer it on the left, please follow the appropriate 
instructions: 
For models FF6B, FF7 and FF7B
1.  Take off the upper hinge cover from the door and remove the screws that hold the top 
hinge. 
2.  Lift the hinge straight up to free the hinge pin from the socket in the top of the door. 
3.  Lift the door up and away to free its bottom socket from the hinge pin. 
4.  Remove the screws to the bottom hinge. 
5.  Remove the decorative caps from the opposite side and plug the holes from the 
original side with the decorative caps. 
6.  Move the bottom hinge to the opposite side and tighten the screws. Use any lock 
washers or nuts if they were installed in the original installation. 
7.  Replace door onto the hinge pin on the bottom hinge. Place top hinge pin into door. 
Insert screws into the top hinge and tighten. 
 
 
 
 
 
 
If you notice the door not hanging straight, loosen the top hinge screws, adjust the door 
until it is level and tighten the screws.