Marvel 15" Built-In Ice Maker - Black Cabinet and Black Door User Manual
Problem
Possible Cause
Remedy
Unit operates but does not produce any
ice
• The unit has just been started and it
has been less than 24 hours.
• Water supply is not turned on.
• Inadequate water pressure to unit.
• The ice maker shut off arm is in the
uppermost position.
• Freezer section has not reached
temperature.
• Thermostat control set too warm.
• Condenser fan air flow is restricted.
• Room and/or water temperature is
too warm.
• Typical ice production is 12 pounds
per day. Allow for the freezer section
to reach temperature and the ice
maker to cycle and accumulate ice.
• Turn on water supply to the unit.
• Water pressure to the unit must be at
a minimum of 20 psi.
• When the ice maker shut off arm is
in the uppermost position, the ice
maker is off. Flip the shut off arm
down to turn on the ice maker.
• Allow the freezer section to reach
temperature.
• Turn the temperature control to a
higher number to allow the unit to
run colder. Allow 24 hours before
readjusting the temperature control.
• Make certain the grille in front of the
unit is free and open for air circula-
tion. Clean grille as required.
• Move the unit to an area where
ambient temperature is below 90°F.
The unit should not be placed next to
a heat source such as an oven. Check
for cold water connection.
Small ice cubes
• Water input may require adjustment. • Due to differing water pressures, the
ice maker water input may require
adjustment. See Figure 8 on page 7
for water adjustment screw location.
Ice cubes are sticking together.
• Ice consumption is low.
• Room temperature is too warm.
• Use the ice in the bin frequently. Ice
will stick together if left in insulated
bin over long periods of time.
• Move the unit to an area that is
below 90°F.
16
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualified service technician.
Electrocution Hazard
- Never attempt to repair or perform
maintenance on the unit until the main electrical power has
been disconnected. Turning the unit control “OFF” does not
remove electrical power from the units wiring.
TROUBLESHOOTING YOUR ICE MACHINE