Wine Guardian 1/2 Ton 5,500 BTU Wine Cellar Cooling Unit Installation Instruction
21
Planning the Installation
Addressing Items in the Planning Process
√ Where to locate the unit? Should it be built into the wall or mounted remote and ducted into
the cellar.
√ How to mount the unit?
√ Decide where to locate the supply and return grilles in the room to achieve the temperature
√ Decide where to locate the supply and return grilles in the room to achieve the temperature
gradient and circulation preferred.
√ Locate the electrical power outlet close to the unit. Do not use an extension cord!
√ Does the condenser heat exhaust need to be ducted away?
√ Where to locate the thermostat?
√ Where to run the drain line?
√ Are all the parts here to complete the installation?
√ Does the condenser heat exhaust need to be ducted away?
√ Where to locate the thermostat?
√ Where to run the drain line?
√ Are all the parts here to complete the installation?
Performing a Pre-installation Check
√ Check for the proper installation of the electrical plug configuration.
√ Check for the properly sized breaker.
√ Is the cellar built with adequate insulation and vapor barriers? See the Wine Cellar Design
√ Check for the properly sized breaker.
√ Is the cellar built with adequate insulation and vapor barriers? See the Wine Cellar Design
Guide at the Wine Guardian’s web site www.wineguardian.com for more information.
√ Are ducts installed above the ceiling or in accessible places properly sized before being
covered.
√ Is enough space available around the unit for service and repair?