Kegco Commercial Deep Well Bottle Cooler - 18 cu. ft. Capacity User Manual
www.kegco.com
6
1-888-980-4810
Setting the Temperature
The Kegco Deep Well Bottle Cooler is factory-set to maintain an average temperature of 38°F in refrigeration when
installed correctly in the proper environment. To maintain a different temperature, simply adjust the control knob
located inside the unit. Avoid opening and closing the door of the cooler too often to ensure a consistent temperature
inside the unit.
The temperature range of the thermostat goes from 32°F to 41°F
(-0.5°C to 5°C). Adjust the thermostat between 7 (coldest) to 1
(warmest) to reach the desired temperature range. To turn off
the cooler, turn the control knob to the “OFF” position.
CAUTION: Leaving the temperature control on the coldest setting
may cause the evaporator coil to freeze and ice up. This will
eventually result in a warmer cabinet temperature.
If you are going on vacation, you may leave the cooler operating during vacations of less than three weeks. If the
appliance will not be used for several months, you should remove all items and turn off the appliance. Clean and dry the
interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
Care and Maintenance
Cleaning your cooler:
• Turn off the power, unplug the appliance, and remove all items.
• Wash the inside surfaces with warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse and wipe dry with a clean soft cloth.
• Do not use steel wool or a steel brush, caustic soap, abrasive cleaners or bleach on the stainless steel. These will
damage the stainless steel or contaminate the stainless steel with steel particles and rusting may occur.
• Wash door gaskets on a regular basis, preferably weekly. Simply remove the door gasket from the frame of the
door, soak in warm water and soap for 30 minutes, dry with a soft cloth, and replace.
• Check door gaskets for a proper seal after they are replaced.
• Periodically remove the shelves and pilasters from the unit and clean them with mild soap and warm water. To
remove the pilasters, first remove the shelves and shelf brackets. Then, simply lift the pilaster up and out.
• It is recommended to clean the unit completely inside and out yearly to maximize the longevity of the product.
Cleaning the condenser coil:
• For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. We
recommend clearing the condenser coil and fins at least once per month.
• Turn off the power and unplug the appliance.
• Clean with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the
condenser fins from top to bottom, not side to side.
• After cleaning, straighten any bent condenser fins with a fin comb.
Cleaning the fan blade and motor:
• If necessary, clean the fan blades and motor with a soft cloth
• If it is necessary to wash the fan blades, cover the fan motor to prevent moisture damage.