Summit 3.2 Cu. Ft. ADA Compliant All Freezer - White Cabinet & Door User Manual
11
Switching on the Empty Freezer
Plug in the freezer and set the thermostat to the super position (continuous
operation). (The red and yellow control lights are on.) When the red light goes off,
set the thermostat for normal operation. Wait a couple of hours, then load the
freezer.
operation). (The red and yellow control lights are on.) When the red light goes off,
set the thermostat for normal operation. Wait a couple of hours, then load the
freezer.
:
Freezing Procedure
To freeze larger amounts of unfrozen items (5 pounds or more), turn the thermostat
knob to super for continuous operation (yellow light is on). After an hour or so, turn
the thermostat down to its normal setting (yellow light goes off) and load the freezer.
After 24 hours, all items should be frozen.
knob to super for continuous operation (yellow light is on). After an hour or so, turn
the thermostat down to its normal setting (yellow light goes off) and load the freezer.
After 24 hours, all items should be frozen.
:
NOTES:
1. Keep unfrozen items out of contact with frozen ones.
2. There is no need to set the thermostat for continuous operation (super) if you only
1. Keep unfrozen items out of contact with frozen ones.
2. There is no need to set the thermostat for continuous operation (super) if you only
intend to freeze smaller quantities of fresh items (4 pounds or less).
Temperature Control for ADA models and models ALF620, ALF620BI,
ALF620L and ALFB621
The temperature inside these freezers is controlled by a digital thermostat located in the
kick plate at the front of the unit. Normally, the LED display shows the current
temperature inside the unit. Temperature readings are in degrees Celsius.
kick plate at the front of the unit. Normally, the LED display shows the current
temperature inside the unit. Temperature readings are in degrees Celsius.
:
The preset temperature range of the thermostat is -10 to -25ºC * (14 to -13°F),
and the
operating temperature is factory-set at
-25ºC (-13°F)
.
If you find that it is necessary to
change the temperature setting (Set Point) for your appliance, refer to the instructions
below.
below.
The front panel of the digital thermostat is shown here:
To see the Set Point:
Push and immediately release the SET key. The display will show the Set Point
value. Wait 5 seconds and the interior temperature will display again.
Push and immediately release the SET key. The display will show the Set Point
value. Wait 5 seconds and the interior temperature will display again.
To change the Set Point:
1.
Push and hold the SET key for more than 3 seconds to change the Set Point
value. The value of the Set Point will be displayed.
value. The value of the Set Point will be displayed.
2.
Push the UP or DOWN arrow to the desired setting. The new setting will be
memorized after 15 seconds, provided no other keys are pushed.
memorized after 15 seconds, provided no other keys are pushed.
* The maximum/minimum range of the digital thermostat (-10 to -25ºC
)
is
preset and
locked by us. To reset this range lock, either call us at 800-932-4267 or find
information on our website under Troubleshooting.
information on our website under Troubleshooting.