Summit 3.2 Cu. Ft. ADA Compliant All Freezer - White Cabinet & Door User Manual
6
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
power cord is damaged, have it replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Installation Instructions
Before Using Your Freezer
•
Remove the exterior and interior packing.
:
•
Check to be sure you have all of the following parts:
3 drawers
1 short drain tube
2 keys (VT65ML and ALF620L models only)
•
CAUTION: After unpacking you MUST allow this appliance to stand upright for at
least 2 hours to allow the lubricant and refrigerant to drain back into the
compressor and stabilize. Failure to do so may adversely affect performance and
the lifetime of your unit.
compressor and stabilize. Failure to do so may adversely affect performance and
the lifetime of your unit.
•
Remove the drawers and clean them and the interior surfaces of the unit with
lukewarm water using a soft cloth.
lukewarm water using a soft cloth.
Installing the Freezer
• Place the unit on a floor that is strong enough to support the appliance when it is fully
loaded. To level the unit, adjust the two leveling legs at the front.
:
• Unless the model numbers include the letters BI, these appliances are designed to be
free-standing only, and should not be recessed or built in. When installing, allow at
least 5 inches of space at the sides and top of the unit and 2 inches at the rear, which
will allow the proper air circulation to cool the compressor and condenser.
least 5 inches of space at the sides and top of the unit and 2 inches at the rear, which
will allow the proper air circulation to cool the compressor and condenser.
If your model has the letters BI in its model number, the appliance can be installed
either free-standing or built-in. If the unit will be built into an enclosure, you must still
allow at least 3/16” of clear space on both sides and at the top, and 2” at the back.
Take care that the air vents at the front are never covered or blocked in any way.
either free-standing or built-in. If the unit will be built into an enclosure, you must still
allow at least 3/16” of clear space on both sides and at the top, and 2” at the back.
Take care that the air vents at the front are never covered or blocked in any way.
• Locate the unit away from direct sunlight and sources of heat (oven, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also affect the
unit's performance.
electrical consumption. Extremely cold ambient temperatures may also affect the
unit's performance.
• Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to
form quickly on the evaporator, requiring more frequent defrosting of the freezer.
• Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or authorized service center.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or authorized service center.
Electrical Connection
: