Electrolux E30WV60PPS Owner's Manual
10
Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
Electrical Shock Hazard
Warning: Turn off power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE GROUND-
ING WIRE IN YOUR HOME ELECTRICAL SYSTEM,
AND IT MUST UNDER NO CIRCUMSTANCES BE
CUT OR REMOVED.
Failure to do so can result in death or electrical
shock.
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE GROUND-
ING WIRE IN YOUR HOME ELECTRICAL SYSTEM,
AND IT MUST UNDER NO CIRCUMSTANCES BE
CUT OR REMOVED.
Failure to do so can result in death or electrical
shock.
•
Remove the knockout and the Junction box
cover and install the conduit connector (cULus
listed) in junction box.
•
Run 3 wires; black, white and green, according
to the National Electrical Code and local codes
and ordinances, in
1
⁄
2
” conduit from service
panel to junction box.
•
Connect black wire from service panel to black
or red in junction box, white to white and green
to green-yellow.
•
Close and secure junction box cover.
Final installation step
•
Replace the 2 lateral supports.
•
Replace filters.
•
Check operation of the hood.
If range hood does not operate:
•
Check that the circuit breaker is not tripped or
the house fuse blown.
•
Disconnect power supply.
•
Check that wiring is correct.
Keep your Installation Instructions and Use and Care
Guide close to range hood for easy reference.
Electrical connection
Description of the Hood
1
2
3
4
5
6
1. Blower control switch
2. Light control switch
3. Lamp housings
4. Grease filter Handle
5. Grease filter
6. Serial / Rating plate
(see page 6)
Controls
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating
cooking.
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating
cooking.
Description of control panel
1. Light Control
•
Turn the light switch (1) to the right 1 position for
HIGH.
•
Turn the light switch (1) to the right 2 positions for
LOW.
•
To turn the lights OFF, rotate the light switch (1) to
the left to the OFF position.
2. Fan Control
The fan has 4 speeds.
The fan has 4 speeds.
•
Rotate the fan switch (2) to the right to turn the fan
ON. Continue to rotate the switch to the desired
fan speed.
•
To turn the fan OFF, rotate the fan speed (2) switch
to the left to the OFF position.