Electrolux ZCV920H Owner's Manual

3

The central vacuum is designed for dry pick-up of household dirt and 
dust. Avoid picking up hard or sharp objects with this system to prevent 
hose and plastic pipe damage or clogs. 

This manual will cover the fi nal steps of installation of the power unit in 
your home. It will also provide the necessary information for maintenance 
and trouble shooting, in the unlikely event that it will be needed. If you 
require further information about installation or inquires on the product 
please contact your local authorized dealer/distributor.

For wall preparations and cover preparations, 
safety equipment such as helmet, gloves, goggles 
and hearing protection are recommended.

Use caution when drilling holes in walls as gas pipelines and water pipes 
and electrical wires may be present. 

If you have any questions regarding the product, spare parts, service, warranty 
or anything else, please contact your local authorized dealer or distributor.

This appliance must be grounded. If it should malfunction or breakdown, 
grounding provides a path of least resistance for electrical current to reduce 
the risk of electrical shock. This appliance is equipped with a cord having 
an equipment-grounding conductor and grounding plug. The plug must
be plugged into an appropriate outlet that is properly installed and 
grounded in accordance with all local codes and ordinances. 

Improper connection of the equipment-grounding conductor can result in 
electrical shock. Check with a qualifi ed electrician or service person if you are 
in doubt as to whether the outlet is properly grounded, or if the plug does 
not fi t into an outlet. Do not modify the plug provided with the appliance.
Have a proper outlet installed by a qualifi ed electrician.

This appliance is for use on a nominal 120 volt circuit and has a grounding plug 
that looks like the plug illustrated in Figure A. Make sure that the appliance is 
connected to an outlet having the same confi guration as the plug. 
No adapter should be used with the appliance.

NOTE: In Canada, the use of a temporary adapter 
is not permitted by the Canadian Electrical Code.

If the supply cord is damaged, it must be replaced by a special cord 
available from your local authorized dealer/distributor. 

The instructions in this booklet serve as a guide to routine maintenance. For 
additional information, contact you’re nearest authorized dealer/distributor.

The type, model, and serial numbers are indicated on the rating plate 

located on the control panel or motor hood. For prompt and complete service 
information, always refer to these numbers when inquiring about service.

Non-observance of the safety directions may result in bodily harm. 

Refer to page 8 - Image 1

This symbol on the product or on its packaging indicates that this product 
may not be treated as household waste. Instead it should be handed over 
to applicable collection point for the recycling of electronics and electrical 
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling 
of this product. For more detailed information about this product, please 
contact your local waste disposal service or the shop where you purchased 
the product.

Your home is most likely already fi tted with the system of plastic pipes 
and inlet valves and you are ready to install the central power unit. If your 
home is not fi tted for a central vacuum system, you can contract to have 
the Central Vacuum System installed by a professional by contacting 
your local dealer or distributor or choose to do-it-yourself. 

The central power unit should be located as far away from the general living 
area as possible, yet accessible so you can remove the dirt receptacle, reach 
the fi lter, and inspect the central power unit.  A typical location would be in a 
garage, where you could vacuum your car or garage area, and where emptying 
the dirt receptacle and cleaning the fi lter would be more convenient. Other suit-
able locations are in the basement, laundry room, or ventilated storage room. 

Use caution when drilling holes in walls as gas pipelines and water pipes 
and electrical wires may be present. Holes in the masonry are only 
allowable through it, if its standing stability is not impaired. Holes in wood 
studs should be drilled. Depending on what material your home is 
built with, use the appropriate anchors to hang your power unit. Power unit 
simply slides onto mounting bracket and clicks into place.

Refer to page 8 - Image 3

•  Place the central power unit in a place that is removed from the general 

living area. The exhaust should be easy to connect to a ventilation pipe. 
This can be done regardless of the house’s construction material.

•  Locate the two low voltage wires near the main pipe. Remove the 

insulation from the low volt wire. Insert the low volt wire into the spring 
loaded low volt connectors. Be certain you comply with your local 
electrical codes and regulations.

Refer to page 8 - Image 4 

•  Make sure there is a dedicated electric socket for the power unit.

•  Plug in your CVS with the supplied power cord.