Electrolux EI30DD10KS Installation Instruction

- Align the cooktop with the downdraft and fasten 

cooktop in place.

- Plug the downdraft’s power cord into the outlet.

- Make sure the power cord is routed beneath the 

appliance and away from heat generated by the 

cooktop.

All ductworks must be as installed as per local codes.

Accurate alignment of cooktop and downdraft is 

necessary to ensure that there is no interference 

when air vent is raised and lowered. There should 

be a gap of 1/8” between the back of the cooktop 

and the front of the downdraft cover.

Local building codes must be followed in specifying 

approved type and specifications of ALL duct used. 

Always use an appropriate roof or wall cap with damper.

Screw

Air Flow

The Transition Base must be installed with the flange 

at the top. Position the duct Transition Cover on the 

Transition Base for the discharge direction selected. 

The top edge of the duct Transition Cover must be 

under the tabs of the Transition Base.

Down Discharge – Attach the transition with 4 screws 

as shown.

- Use galvanized or aluminum duct in 8” or 10” round 

or 3 ¼” x 14” size, or a combination of both. PVC 

duct should be used if installing under a poured 

concrete slab. Use the shortest and straightest duct 

run possible.

Transition 

Base

Remove Phillips 

Head Screw 

from Left Hole 

and Reattach as 

Shown

Duct Transition 

Cover

(4) Phillips 

Head Screws

(4) Phillips 

Head 

Screws

(4) Phillips 

Head Screws

Remove Phillips 

Head Screw from 

Right Hole and Attach 

as Shown

Discharge Down (as supplied)

Discharge Left

Discharge Right

Left or Right Discharge – Remove the Phillips head 

screw from the chassis.  Attach the transition with 5 

screws as shown.