Woodstock M1103 User Manual
-18-
M1102/M1103 16-Speed Drill Press
SE
T
U
P
The Model M1102/M1103 includes a 110V light socket for
an optional light bulb. When the drill press is shipped
from the factory, a dust plug is installed in the light sock-
et for protection.
To install a light bulb in the drill press, do these steps:
1. DISCONNECT THE DRILL PRESS FROM POWER!
2. Remove the dust plug from the light socket at the
underside of the headstock.
3. Install a 60W or less light bulb.
Work Light
Test Run
Once assembly is complete, you are ready to test run the
drill press.
To test run the drill press:
1. Plug the drill press into the power.
2. With your finger poised on the paddle switch (in
case there is a problem), flip the START button
ON.
The drill press should run smoothly, with little or no
vibration or rubbing noises.
Investigate and correct for strange or unusual noises
before operating the machine further.
If you cannot easily locate the source of a potential
problem, refer to
Troubleshooting on Page 27.
Use only bulbs that are “safety coated” and shatter
resistant. The bulb will be exposed at the bottom
of the head casting which helps with illumination.
Impacts with a bulb not “safety coated” may shat-
ter, exposing the electrical filaments and creating an
electrical shock hazard.
Always wear safety glasses when oper-
ating the drill press. Failure to comply
may result in serious personal injury.
Keep loose clothing rolled up and out
of the way of machinery and keep hair
pulled back.