Xerox 6600/DN User Manual

Page of 190
Regulatory Information 
 
 
Phaser 6600 Color Printer 
181 
 
User Guide 
 
European Union 
 
 
CAUTION: 
This is a Class A product. In a domestic environment, this product can cause radio 
interference in which case the user could be required to take adequate measures. 
 
The CE mark applied to this product symbolizes a declaration of conformity by Xerox 
with the following applicable Directives of the European Union as of the dates indicated: 
•  December 12, 2006: Low Voltage Directive 2006/95/EC 
•  December 15, 2004: Electromagnetic Compatibility Directive 2004/108/EC 
This printer, if used properly in accordance with the instructions, is not dangerous for the consumer 
or for the environment. 
To ensure compliance with European Union regulations, use shielded interface cables. 
A signed copy of the Declaration of Conformity for this printer can be obtained from Xerox. 
 
European Union Lot 4 Imaging Equipment Agreement Environmental 
Information 
Environmental Information Providing Environmental Solutions and Reducing 
Cost 
Introduction 
The following information has been developed to assist users and has been issued in relation to the 
European Union (EU) Energy Related Products Directive, specifically the Lot 4 study on Imaging 
Equipment. This requires manufacturers to improve environmental performance of in scope products 
and supports the EU action plan on energy efficiency. 
In scope products are Household and Office equipment that meet the following criteria. 
•  Standard monochrome format products with a maximum speed less than 66 A4 images per 
minute 
•  Standard color format products with a maximum speed less than 51 A4 images per minute 
 
Environmental Benefits of Duplex Printing 
Most Xerox
®
 products have duplex printing, also known as 2-sided printing, capability. This enables 
you to print on both sides of the paper automatically, and therefore helps to reduce the use of 
valuable resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement 
requires that on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm 
monochrome the duplex function has been auto enabled, during the setup and driver installation. 
Some Xerox
®
 models below these speed bands may also be enabled with 2-sided printing settings 
defaulted on at the time of install. Continuing to use the duplex function will reduce the environmental 
impact of your work. However, should you require simplex/1-sided printing, you may change the print 
settings in the print driver.