Xerox DocuPrint 180 User Manual

PRODUCT DIFFERENCES/USER CONSIDERATIONS

XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE

5-3

Using your Xerox DocuPrint 180 LPS as a backup LPS

Tables 5-1 through 5-6 identify particular job features to consider
when printing a job on your Xerox DocuPrint 180 LPS which was
created on another Xerox LPS running a different software version.
Each table contains specific job features which may be encountered,
the projected results when printed on your Xerox DocuPrint 180 LPS,
and where to find further information.

Table 5-1.

Will this 4635 (V3A R1.7) job print on my Xerox
DocuPrint 180 LPS

Job features from 4635
(V3A2 R1.7)

Results when run on DP 180 LPS

Programmable bypass
transport

Job prints if DP 180 LPS has a bypass
transport and the finishing device is
required by the job. Otherwise, it does
not run.

Clusters

Job prints. Operator needs to redefine
clusters if trays differ.

Edgemarking

Job prints

Fonts

Job prints if the fonts and character sets
used are loaded on the DocuPrint 180
LPS or if substi-tutions for these fonts
are defined.

Graphics

Job prints if sufficient graphic memory is
available.

Labels

Job prints using only paper labels. Refer
to the

Xerox DP 180 LPS Operator

Guide

for loading instructions.

Page density

Job prints.

Paper sizes

Job prints.

Paper stock

Job prints if it does not use edge
reinforced 3-hole stock.

Stitch commands

No stitcher available on DP 180 LPS,
therefore stitch commands are ignored
and job prints unstitched.

Transparencies

Job prints.

MICR