Xerox DC220/230ST Leaflet

 

Access the AppleTalk Setup screens:

On the screen display, press [Print 
Setups].

Press [Network Setups].

Press [AppleTalk].

Enable AppleTalk:

Press [Enablement].

Press [Enabled].

Press [Printer Name], then press 
[Edit] and use the keyboard displayed 
on the screen to enter the Printer 
Name for your network (31 characters, 
or less).

Press [Save].

Press [Save].

Press [Exit].  The DC220/230 will reboot 
and print a configuration sheet in approxi-
mately 3 minutes.

Check the settings on the configuration 
sheet against those that were entered.

To install the DC220/230 Macintosh

 

PPD:

Copy the DC220/230 Macintosh PPD 

from the CentreWare

 CD to the 

System Folder/Extensions/Printer 
Descriptions folder.

Set up and configure the Print Driver 
via the Chooser.

Refer to the CentreWare

®

manual, 

Getting Started with Print and Fax 
Services for additional information.

Additional information on the AppleTalk 
installation can be found in the DC220/230 
System Administration Guide.

Record the following information for use during 
setup at the DC220/230:

AppleTalk Printer Name:

______________________________________

Note: The DC220/230 will attach itself to the 
default zone of the local segment where it is 
connected.

Connect the DC220/230 to your network 
outlet or cable.

Enter System Administrator Setups:

Press the [Access] button on the 
Control Panel.

Enter the System Administrator 

password by typing

(# key and 22222) on the keypad and 
pressing [Enter] on the screen.

Note: #22222 is the factory default 
password and may be changed by 
your Xerox service representative to 
suit your needs.

©1998 Xerox Corporation
701P97986

Version 1.1, 5-98

For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797      Canada: 1-800-939-3769