Nortel Networks 400 4.0 User Manual
120
Chapter 8 Installing a media bay module (MBM)
N0060612
N0060612
Setting MBM DIP switches
Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of
these settings either on the chart shown in
these settings either on the chart shown in
or in the Programming Record form.
To set MBM DIP switches
1
Locate the DIP switches on the MBM. See
.
Figure 70 MBM DIP switches
2
Set the switches to correspond with the settings you chose in the procedure
3
Repeat step 2 for each MBM you want to install.
Note: The GASM and GATM MBMs have a different DIP switch configuration
than shown in
than shown in
6 5 4 3 2 1
Off
On
Underside of the
MBM
MBM
DIP switches
Back of the MBM
1 2 3 4 5 6
On
Off
Rear view of the MBM
MBM is
right-side up
right-side up