Nortel Networks 400 4.0 User Manual
Chapter 17 Using the Startup Profile to configure parameters
209
BCM200/400 4.0 Installation and Maintenance Guide
The Startup Profile is now loaded on your BCM system.
Startup Profile times and LED sequence
provides details about the BCM system boot times and LED sequence using the Startup
Profile to configure system parameters.
Next step
After you have loaded the Startup Profile, you can complete the installation process. Refer to
Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM system.
storage device from the BCM system.
Table 76 Startup Profile times and LED sequence
Duration
(minutes)
(minutes)
Cummulative
time
(minutes)
time
(minutes)
Power LED
Status LED
Comments
2
2
Solid green
Flashing green
4
6
Solid red
off
2
8
Solid green
Solid green
Initial boot sequence complete
30
38
Solid red
Solid green
Startup Profile functioning. Duration
varies depending on selected
parameters.
varies depending on selected
parameters.
2
40
Solid green
Flashing green
Off (error)
Startup Profile is successfully applied.
If there is an error the remaining steps
are not completed.
are not completed.
4
44
Solid red
off
Duration varies based on selected
parameters.
parameters.
2
46
Solid green
Solid green
Reboot complete and system is
functional.
functional.
Note: You can safely remove USB
device.
device.
Note 1: If you use Element Manager to configure the parameters, the overall times are similar. Startup Profile
enables you to configure multiple parameters at once, rather than individually using Element Manager.
enables you to configure multiple parameters at once, rather than individually using Element Manager.
Note 2: To re-apply the Startup Profile, remove the applied keycode file by returning the system to factory defaults
using the BIT tool.
using the BIT tool.