Nortel Networks 400 4.0 User Manual
250
Chapter 21 Replacing a media bay module
N0060612
N0060612
Removing an MBM
Use the procedures is this section to remove one or more MBMs from a BCM main unit or
expansion unit.
expansion unit.
To remove an MBM
1
Power down the BCM system (see
).
2
Remove any cabling from the MBM faceplate.
3
Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers.
Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the
bay. Refer to
Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the
bay. Refer to
,
.
4
Grasp the top and bottom edges of the MBM. Remove the MBM from the BCM unit (see
, and
). Place the MBM in a clean, safe, and static-free area.
Figure 119 Remove a BCM200 MBM
Grasp the edge of the MBM
ejector lever and pull outward
ejector lever and pull outward