Nortel Networks 400 4.0 User Manual
Chapter 22 Replacing the hard disk
265
BCM200/400 4.0 Installation and Maintenance Guide
9
Restore the BCM system to operation. Refer to
.
10 If you installed a new programmed hard disk in a standard configuration (for RAID
configuration, skip to the next step):
a
Initialize the hard disk. Refer to
.
b
After the disk is initialized, restore your data from your backups. If you did not back up
your keycodes, reenter them (see
your keycodes, reenter them (see
).
11 If you installed a new blank hard disk (mirror or primary) in a RAID, wait for the disk mirror
process to complete. For further information on how to monitor disk mirroring progress, refer
to
to
Replacing a hard disk in the hard disk cage
Use the procedures in this section to remove or install the hard disk in the hard disk cage for the
standard and RAID upgrade BCM200 and BCM400 configurations.
standard and RAID upgrade BCM200 and BCM400 configurations.
Refer to the following detailed information:
•
•
•
•
•
•
Removing a hard disk from a standard configuration hard disk cage
Use this procedure to remove the hard disk from the hard disk cage for the standard BCM200 and
BCM400 system. Use this procedure only to replace a faulty hard disk.
BCM400 system. Use this procedure only to replace a faulty hard disk.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.