ZyXEL Communications VSG-1200 User Manual
VSG-1200 User’s Guide
38
Chapter 2 Hardware Installation and Connection
2.2.1.5 The Reset Button
Use a pointed object to press this button in once to reset the VSG back to the factory defaults.
2.2.2 Front Panel LEDs
The following table describes the LEDs on the front panel. When turned on, all LEDs are
green unless otherwise specified.
green unless otherwise specified.
2.2.3 Rear Panel
The power socket, the fan and a ventilation hole are located on the rear panel as shown next.
Figure 7 Rear Panel
Note: All your custom configuration including the system usernames and
passwords will be erased.
passwords will be erased.
This will NOT delete the subscriber database or the port-location mappings.
Table 1 Front Panel LEDs
LED
STATUS
DESCRIPTION
PWR
On
The VSG is receiving power.
Off
The VSG is not receiving power.
ALARM
On (Red)
There is a hardware failure.
Blink Once (Red)
The system is starting up.
Off
The system is functioning normally.
LAN or WAN
LK/ACT
On
The port is connected to an Ethernet device.
Blinking
The port is receiving or sending data.
Off
The port is not connected to an Ethernet device.
10/100
On
The port is operating at 100 Mpbs.
Off
The port is operating at 10 Mpbs.
FDX
On
The port is operating in full-duplex mode.
Off
The port is operating in half-duplex mode.
Note: Do NOT block the ventilation hole.