Motorola MPC8260 User Manual
MOTOROLA
Chapter 26. Serial Management Controllers (SMCs)
26-31
Part IV. Communications Processor Module
26.5.2 Handling the GCI Monitor Channel
The following sections describe how the GCI monitor channel is handled.
26.5.2.1 SMC GCI Monitor Channel Transmission Process
Monitor channel 0 is used to exchange data with a layer 1 device (reading and writing
internal registers and transferring of the S and Q bits). Monitor channel 1 is used for
programming and controlling voice/data modules such as CODECs. The core writes the
byte into the TxBD. The SMC sends the data on the monitor channel and handles the A and
E control bits according to the GCI monitor channel protocol. The
internal registers and transferring of the S and Q bits). Monitor channel 1 is used for
programming and controlling voice/data modules such as CODECs. The core writes the
byte into the TxBD. The SMC sends the data on the monitor channel and handles the A and
E control bits according to the GCI monitor channel protocol. The
TIMEOUT
command
resolves deadlocks when errors in the A and E bit states occur on the data line.
26.5.2.2 SMC GCI Monitor Channel Reception Process
The SMC receives data and handles the A and E control bits according to the GCI monitor
channel protocol. When the CP stores a received data byte in the SMC RxBD, a maskable
interrupt is generated. A
channel protocol. When the CP stores a received data byte in the SMC RxBD, a maskable
interrupt is generated. A
TRANSMIT
ABORT
REQUEST
command causes the MPC8260 to
send an abort request on the E bit.
26.5.3 Handling the GCI C/I Channel
The C/I channel is used to control the layer 1 device. The layer 2 device in the TE sends
commands and receives indication to or from the upstream layer 1 device through C/I
channel 0. In the SCIT conÞguration, C/I channel 1 is used to convey real-time status
information between the layer 2 device and nonlayer 1 peripheral devices (CODECs).
commands and receives indication to or from the upstream layer 1 device through C/I
channel 0. In the SCIT conÞguration, C/I channel 1 is used to convey real-time status
information between the layer 2 device and nonlayer 1 peripheral devices (CODECs).
26.5.3.1 SMC GCI C/I Channel Transmission Process
The core writes the data byte into the C/I TxBD and the SMC transmits the data
continuously on the C/I channel to the physical layer device.
continuously on the C/I channel to the physical layer device.
26.5.3.2 SMC GCI C/I Channel Reception Process
The SMC receiver continuously monitors the C/I channel. When it recognizes a change in
the data and this value is received in two successive frames, it is interpreted as valid data.
This is called the double last-look method. The CP stores the received data byte in the C/I
RxBD and a maskable interrupt is generated. If the SMC is conÞgured to support SCIT
channel 1, the double last-look method is not used.
the data and this value is received in two successive frames, it is interpreted as valid data.
This is called the double last-look method. The CP stores the received data byte in the C/I
RxBD and a maskable interrupt is generated. If the SMC is conÞgured to support SCIT
channel 1, the double last-look method is not used.