Phoenix Gold TI1600.5 User Manual

FRONT/REAR/ SUB INPUT

Connect signal cables from the head unit to these terminals.

2ch/4ch/5ch INPUT SELECTOR

2ch: Headunit has one pair of cables into front Input.

4ch: Headunit has two pairs of cables into front and rear inputs.

5ch: Headunit has three pairs of cables into front, rear and sub inputs. 

HP/LP CROSSOVER FREQUENCY

Controls the crossover point for the speaker outputs. 

CONFIG

FLAT/OFF: Crossovers are turned off

HP: High pass crossover is on

LP/BP:  Low and High Pass crossovers are both on, creating a Bandpass (BP) 

setting for midbass drivers. 

Notes: The front HP and rear LP crossovers extend to 4kHz, so its possible 

to run a component speaker system fully active. The tweeters would be 

powered by the front channels and the midbasses by the rear channels. Be 

sure to check with your speaker’s manufacture for the correct tweeter and 

midbass crossover points to avoid speaker damage. 

Subwoofer channel LP crossover and subsonic filter are always on.

LEVEL

Used to reach maximum amplifier power with a wide variety of headunits.

FRONT AND REAR SPEAKER OUTPUTS

Used to connect the amplifier to speakers. Minimum impedance is 2 ohm stereo/4 ohm 
bridged. Use left channel + and right channel - for bridged mode.

SUB CHANNEL SPEAKER OUTPUTS

Used to connect the amplifier to subwoofers. Minimum impedance is 1 ohm.

© 2011 Phoenix Gold • www.phoenixgold.com