Radio Shack 10 Disc CD Changer User Manual
25
REPLACING A FUSE
If the CD changer or its components do
not operate, you might need to replace
the fuse from one or more of the power
wires with one of the supplied fuses.
Check all fuses.
not operate, you might need to replace
the fuse from one or more of the power
wires with one of the supplied fuses.
Check all fuses.
The fuse for the yellow power wire on
the CD changer must be 5.0 amps. On
the Audio Adapter, the red power wire’s
fuse should be 0.5 amps, while the yel-
low continuous power wire’s fuse must
be 5 amps.
the CD changer must be 5.0 amps. On
the Audio Adapter, the red power wire’s
fuse should be 0.5 amps, while the yel-
low continuous power wire’s fuse must
be 5 amps.
Warning: Before you begin, disconnect
the cable from the vehicle battery’s neg-
ative (–) terminal.
the cable from the vehicle battery’s neg-
ative (–) terminal.
1. Unlatch the two latches on the fuse
holder, so the holder springs open.
2. If a fuse is blown, replace it. Use
only standard 1
1
/
4
-inch fuses with
the proper rating.
Caution: The supplied spare fuses
have the proper ratings. Make sure
you replace a fuse only with another
fuse of the same rating.
have the proper ratings. Make sure
you replace a fuse only with another
fuse of the same rating.
3. Reassemble the fuse holder by
squeezing it together.
4. Reconnect the cable to the vehicle
battery’s negative (–) terminal.
12-2182.fm Page 25 Friday, September 3, 1999 7:31 AM