Lopi Yankee Bay Pellet Insert User Manual

N O T E :

Attach the vent prior to installing the surround panels (& circuit board).

a

Remove the circuit board from the rear 
hopper support.  Disconnect the wiring 
harness from the circuit board (see step 
“d” below for a detailed view).

Phillips 

Screwdriver

Run the power cord to the side along 
the front of the fireplace behind the side 
panel (do not route it under the insert).

e

Attach the surround panels to the insert by sliding the slots 
on each panel over the tabs on the side of the insert.

Tab

Slot

Attach the circuit board 
with the four screws 
shipped with the insert.

Phillips 

Screwdriver

Right Side 
Surround 
Panel

c

"L" Bracket

Right Side Trim

AA

AA

AA

AA

A

A

A

A

AA

AA

AA

AA

Top Panel

Top Trim

Optional Trim Installation:
Insert one leg of each "L" bracket 
into the top and side trim piece.  
Align the trim to form a precise 
corner, then tighten the two set 
screws with a small standard 
screwdriver.  Slide the trim over 
the panels. Attach the double-
back tape between the trim and 
panels at the bottom corners.   
This keeps the trim tight against 
the panel and prevents rattles.

Tighten the set screws 
from the back side with a 
small standard screwdriver

Install the top panel so the joggle clips slide over 
the tabs on top of the side panels and insert.

f

Double-Back Tape

b

Back of 

Side Panel

Bend these block-
off plates as 
shown (both 
sides).  When in 
position, they 
block the view 
through the slots. 
in the surround 
panels.

NOTE: When in place, the 
panels maintain a 3/8” gap 
around the fireplace.

Place the right side surround panel near 

the insert and attach the wiring harness 

to the circuit board.

If using a thermostat, 

attach the thermostat 

wires at this time.

Back Side of 

Circuit Board

Wiring Harness 

(disconnected 

in step “a”)

Pinch these tabs to 

remove the wiring 

harness.

d