Lopi Yankee Bay Pellet Insert User Manual
6
Specifications
Travis Industries
4 0 5 0 5 0 9
1 0 0 - 0 1 1 4 5
Heating Specifications:
Approximate Maximum Heating Capacity (in square feet)* ........................................800 to 2,250
Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5
Maximum Burn Time on Low Burn** ......................................................................28 to 52 Hours
Hopper Capacity (based upon hopper extension position).........................................48 to 89 Pounds
Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5
Maximum Burn Time on Low Burn** ......................................................................28 to 52 Hours
Hopper Capacity (based upon hopper extension position).........................................48 to 89 Pounds
*
Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also
affected by the fuel size, quality, and moisture level.
affected by the fuel size, quality, and moisture level.
**
Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending
on fuel quality may occur.
on fuel quality may occur.
Dimensions:
12"
13-1/4” (allow 14” depth in the Fireplace)
32”
Center of 4” diameter Flue is 16-7/8” above the
baseplate and 7-1/2” left of center
25-3/4” to 20”
See “Hopper Extension Set-up”
for details.
See “Hopper Extension Set-up”
for details.
25-1/2” (allow 36” width for
control board installation)
control board installation)
26-1/2”
45”
Door Opening
Fireplace Opening
28
”
Electrical Specifications:
Electrical Rating.........................................................................................115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence ...................................................................400 (approximately)
Watts During Operation ...............................................................................180 (approximately)
Watts During Start-Up Sequence ...................................................................400 (approximately)
Watts During Operation ...............................................................................180 (approximately)
Fuel:
The unit is designed for wood pellets that comply with the standards set by the Association of Pellet Fuel
Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than 1–1/2", 8200
BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). If the fuel
does not comply to this standard, the unit may not operate as designed.
Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than 1–1/2", 8200
BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). If the fuel
does not comply to this standard, the unit may not operate as designed.
N O T E
: This heater may use alternative fuel if equipped with the multi-fuel fire pot and properly maintained. See the
publication “Multi-Fuel Pellet Fire Pot” for requirements (available from your Travis Industries, Inc. dealer).
EPA Compliance:
This heater is EPA exempt from Phase II requirements, but has been tested for emissions using EPA
test methods by OMNI Test Labs.
test methods by OMNI Test Labs.