Panasonic AJ-SPC700 P User Manual
65
5
Chapter 5 Preparation
(continued)
When using a BP-90 type battery pack
1
Remove the battery holder.
2
Attaching the battery case to the camera-recorder.
Connect the cable on the camera-recorder to the
Connect the cable on the camera-recorder to the
cable on the battery case (BP-90 type).
Using a screwdriver, secure the battery case (BP-90
type) to the camera-recorder.
Open the cover and lift the rubber cap so that the
screw tightening hole is visible. Tighten the screws
to secure the battery case to the camera-recorder.
Be sure to fully tighten the screws.
Open the cover and lift the rubber cap so that the
screw tightening hole is visible. Tighten the screws
to secure the battery case to the camera-recorder.
Be sure to fully tighten the screws.
<Notes>
z Do not use excess force when lifting the rubber caps
forcibly.
z Take special care not to pinch the cable.
3
Connect the battery pack plug to the socket inside the
battery case, and insert the battery pack into the case.
battery case, and insert the battery pack into the case.
<Note>
Make sure you turn OFF the camera-recorder power
before connecting or disconnecting the plug.
before connecting or disconnecting the plug.
4
Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen on the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen on the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.
Battery holder
Connect
Battery Case
(For BP-90 type)
(For BP-90 type)
Label
surface
surface
#,52%2
'PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧝㧞㧤ᣣޓᧁᦐᣣޓඦᓟ㧝㧞ᤨ㧠㧥ಽ