Panasonic TC 22LR30 User Manual

These displays will alert you to a missed operation or provide further instructions.

• A serious, but temporary error has occurred and one of the unit's safety devices has activated. 

Press ENTER. The unit switches to the standby mode. Press POWER to turn the unit on again.

–

• You haven’t inserted a disc. Correctly insert a disc that this unit can use.

9, 34

• The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.

34

• The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R.

9

• You inserted an unformatted DVD-RAM or Card. Format the disc or card with this unit.

61

• The program was copy-guarded.

–

• No space left on the disc.

→  Create space by erasing any unwanted programs. 

→  Use a new disc. 

 

52

• Recording was not completed for some other reason.

–

• No space left on the disc.

→  Create space by erasing any unwanted programs. 

→  Use a new disc. 

 

52

• The operation is prohibited by the unit or disc.

44

• The disc is dirty.

–

• You inserted an incompatible disc (Discs recorded in PAL video etc.).

8

• There may be a problem with the disc. Press OPEN/CLOSE to remove it and check it for 

scratches or dirt. (The unit turns off automatically after you open the tray.)

–

• The card is not inserted. If this message is displayed with a compatible card already inserted, 

turn off the power, remove and then re-insert the card.

34

• The card format does not match.

11

• The card inserted is not compatible.

11

• There is no compatible folder in this unit.

11

• The card is currently protected → Release the write protection.

11

• There is no space remaining. → Erase any unwanted files (still pictures).

55, 56

• The disc is dirty or badly scratched.

→  Clean the disc if it is dirty.
→  The disc cannot be played if it is scratched and this display doesn’t disappear.

10

• The unit cannot read the disc.

–

• You have used a DVD-RAM/PD lens cleaner and it has finished.

76

• You have inserted a disc the unit cannot play or record on.

8~9

• The unit is hot.

→  The unit switches to standby automatically for safety reasons and you cannot operate it. 

Wait for about 30 minutes for the service number to disappear.

→  Select a position with good ventilation when installing the unit.
→  Do not block the cooling fan on the rear of the unit.

–

• The unit fails to operate properly. Press POWER to switch the unit to standby. Now press 

POWER again to turn the unit on.

–

• There was a power failure or the AC plug was disconnected while the power was on. The unit is 

carrying out its recovery process. Wait until the message disappears.

–