Pelco C2943M-B User Manual

20

C2943M-B (1/09)

NOTE: You must wear lead-free gloves and use electrostatic discharge (ESD) equipment when handling cameras.

1. Place the monitor face down, being careful not to scratch or touch the screen.

2. Use the thumb screw on the bottom of the monitor to open the access door. Refer to Figure 13.

Figure 13.  Access Door

3. Unscrew the three metric screws (14 mm) that secure the camera. Remove the screws and spacers.

4. Gently pull the camera out of the monitor, being careful not to damage the attached connection leads. Detach the two camera connection 

leads from the camera.

1. Locate the DIP switch.

2. Set the switches for your installation using a small screwdriver (refer to Figure 14.)

Figure 14.  DIP Switches