Panasonic KX-TG2237S User Manual

The unit does not work.

“No link to base
Place on cradle and

try again.

” is displayed

and an alarm tone sounds.

Static, sound cuts in/out,
fades. Interference from
other electrical units.

The handset and/or the base
unit does not ring.

The handset display is blank.

•Check the settings (p. 11–15).

•Charge the battery fully (p. 12).

•Clean the charge contacts and charge

again (p. 13).

•Install the battery properly (p. 12).

•Place the handset on the base unit and

unplug the AC adaptor to reset. Plug in,
and try again.

•Re-install the battery and place the

handset on the base unit (p. 57). Try
again.

•You are too far from the base unit. Move

closer and try again.

•Place the handset on the base unit and

try again.

•Plug in the AC adaptor.

•Raise the base unit antenna.
•Locate the handset and the base unit

away from other electrical appliances
(p. 3).

•Move closer to the base unit.

•Raise the base unit antenna.

•Press 

Ü

to select a clearer channel in

the talk, speakerphone or intercom
mode.

•The ringer volume is set to OFF. Set to

HIGH or LOW (p. 18).

•When the handset is on the base unit,

the handset does not ring. Only the base
unit rings in the selected pattern when
receiving a call. 

•Charge the battery fully (p. 12).