Casablanca Fan Company C28GXXM User Manual
4
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you
wish to place your Casablanca fan, an approved ceiling
fixture outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and discon-
nect the wiring. Check the ceiling fixture outlet box to be
sure that it is marked ‘Approved for ceiling fan mount-
ing’. If it is not, a new box must be installed.
Warning: To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked acceptable
for ceiling fan support using the mounting hardware
provided with the outlet box.
FLAT WASHER (2)
LAG SCREW AND WASHER
(1)
1″ x 8-32 ROUND
HEAD SCREWS (2)
CAUTION: To reduce the risk of personal
injury, use only the mounting hardware
provided with the approved outlet box to
install the crossbar mounting bracket.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Place the wires from the ceiling outlet box
to one side of the crossbar mounting bracket. Attach
the bracket, with ground wire and ridges down, to the
ceiling fixture outlet box with the mounting hardware
included with the outlet box. Tighten the screws firmly
by hand only, being careful not to bend the bracket by
over tightening.
JOIST
CEILING FIXTURE
OUTLET BOX
(CEILING FAN
RATED)
CROSSBAR
MOUNTING
BRACKET
(RIDGE SIDE
DOWN)
1” X 8-32
ROUND-HEAD
SCREWS (2)
WASHERS
(2)
CEILING
WIRING
GREEN
GROUND
WIRE
LAG SCREW
AND
WASHER (1)