Baby Trend E30FL0211U User Manual

•  Type A: Put the two buckle tongues together, 

overlaying the left buckle tongue onto the 

right buckle tongue, and insert the two joined 

buckle tongues into the harness buckle on 

the crotch strap (Fig. 36-1).  Type B: Insert 

each buckle tongue into the harness buckle 

(Fig. 36-2).  

 

Make sure that you hear the tongues click 

into the buckle and check that both are firmly 

latched by pulling upward on the straps. 

If 

the harness straps are not securely buckled, 

the safety seat will 

NOT provide protection 

for your child.  

DO NOT use the safety seat, 

even as a carrier, if the harness does not 

securely buckle.  Please call Baby Trend at 

1-800-328-7363 for assistance.

 

•  From the front of the Safety Seat, pull outward on the Harness 

Adjuster Strap to tighten the Harness Straps. Make sure that both 

Harness Straps are flat and snug on your child’s shoulders. A snug 

strap should not allow any slack. It lies in a relatively straight line 

without sagging. It does not press on the child’s flesh or push the 

child’s body into an unnatural position.

•  Fasten the Harness Chest Clips together.  Position the Harness 

Chest Clip, by sliding the Clip either up or down on the 

Harness Straps, so that it is level with the child’s armpits. 

Accessory products for use with the Safety Seat are acceptable 

for use provided that they do not interfere with the harness 

assembly, or the proper adjustment of the harness such that it 

remains tight on the child’s shoulders at all times.  

Thick, soft, or 

other compressible material in excess of 1/4 inch thick should 

not be placed behind or under the child or between the child 

and harness straps.

  Examples of accessory products are head 

support pillows or rolled blankets to add additional head support.

Please read carefully section 4.3, 

Belt is Safe to Use, before proceeding with the installation of 

the Safety Seat.  Please understand that due to the extremely 

large number of vehicles in use today, and the correspondingly 

large number of safety belt systems, this section can only provide 

guidance, as to the proper installation of the Safety Seat, that 

must be combined with the information provided by your vehicle 

manufacturer in order to obtain a proper and safe installation.

Failure to properly install and secure the Safety Seat in a rear 

facing position within the vehicle increases the child’s risk of 

death or serious injury in the event of a sharp turn, sudden stop 

or crash.  Carefully follow these instructions, and the instructions 

provided by your vehicle manufacturer for the installation of child 

safety seats, to ensure that the Safety Seat is properly located, 

positioned and held tightly installed at all times.

Fig. 36-1

Fig. 36-2