Honeywell AP-010BT User Manual

Contact information for technical support and product service can be 
found at 

Refer to 

 for your 

product’s warranty information.

USA
FCC Part 15 
This device complies with part 15 of the FCC Rules. Operation is subject to the 

following two conditions:
1, This device may not cause harmful interference.
2. This device must accept any interference received, including interference that 

may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class 

B digital device pursuant to part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installation. If this equipment 

does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

• Consult the dealer or an experienced radio or television technician for help.
If necessary, the user should consult the dealer or an experienced radio/televi-

sion technician for additional suggestions. The user may find the following book-

let helpful: “Something About Interference.” This is available at FCC local 

regional offices. Honeywell is not responsible for any radio or television interfer-

ence caused by unauthorized modifications of this equipment or the substitution 

or attachment of connecting cables and equipment other than those specified 

by Honeywell. The correction is the responsibility of the user.