DELL 8024 and 8024F User Manual

Deploying FCoE (FIP Snooping) on Dell

PowerConnect

10G Switches: M8024-k, 8024, and 8024F

The following CLI commands are necessary for an un-configured Cisco Nexus 5548UP or Cisco Nexus
5596. The full CLI will show additional lines that are either default or can’t be changed and are not
added for this example. The CLI will also show the lines in a different order after they have been
entered.

Appendix-A Cisco Nexus 5548UP CLI example

will have a copy of the full configuration.

Command-Line Interface Method

Sample CLI for Cisco Nexus 5548 (can be copied and pasted)

Figure 11.

Note that the provided Cisco commands should be referenced in the Nexus 5000 Series NX-OS
SAN Switching Configuration Guide.

The CLI entries above only cover the areas that must be added

to enable FCoE capabilities on the particular ports being used of a Cisco Nexus 5020 and Nexus

5548. This topic will be covered after the Step by Step explanation of the CLI example.

feature fcoe
feature npiv
feature telnet
feature lacp

system default switchport trunk mode auto

system qos
  service-policy type qos input fcoe-default-in-policy
  service-policy type queuing input fcoe-default-in-policy
  service-policy type queuing output fcoe-default-out-policy
  service-policy type network-qos fcoe-default-nq-policy

vlan 20
vlan 1000
  fcoe vsan 2


vsan database
  vsan 2
  vsan 2 interface vfc1
  vsan 2 interface fc2/1

interface vfc1
  bind interface Ethernet1/1
  no shutdown

interface fc2/1
  switchport trunk mode auto
  no shutdown

interface Ethernet1/1
  switchport mode trunk
  switchport trunk native vlan 20
  switchport trunk allowed vlan 1000


zone name blade1 vsan 2
  member interface fc2/1
  member pwwn xx:xx:xx:xx:xx:xx:xx:xx

zoneset name set1 vsan 2
  member blade1

zoneset activate name set1 vsan 2