Graco PD204226C User Manual

18

To Install Locking Clip:  
1.   Tighten the buckled belt by pushing down 

hard on the infant restraint and pulling hard  

on the shoulder belt.

2.   While pushing down on the infant restraint, 

pinch the two straps together behind the 

buckle tongue. Unbuckle the belt  

without allowing it to slip.

3.  Connect lap and shoulder belts with locking clip as 

shown ™ and š.

4.  Rebuckle belt. Check that 

lap belt does not move by 

pulling and pushing hard 

on the infant restraint.  

If belt loosens or  

lengthens, repeat  

procedure.

Locking clip

Locking clip goes here,  

1

/

2

 inch (1 cm) from the buckle

This belt has a latch plate that slides 

freely along the belt.
This belt MUST be converted to prevent 

movement of the lap portion of the belt. 

You must use a locking clip (provided 

with the infant restraint) when using the 

infant restraint without the base unless 

your vehicle’s seat belt can be  

converted in another way as described 

in your vehicle owner’s manual.

1

/

2

 inch  

(1 cm)

™

š