3com WX1200 3CRWX120695A User Manual
368
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
Examples — The following command changes the bias for a Distributed
MAP to low:
MAP to low:
WX4400# set dap 1 bias low
success: change accepted.
See Also
set ap blink
Enables or disables LED blink mode on a MAP to make it easy to identify.
When blink mode is enabled on (MAP-xxx models, the health and radio
LEDs alternately blink green and amber. By default, blink mode is
disabled.
When blink mode is enabled on (MAP-xxx models, the health and radio
LEDs alternately blink green and amber. By default, blink mode is
disabled.
Syntax —
set {ap ap-number auto blink {enable | disable}
ap
ap-number
— Index value that identifies the MAP on the WX.
enable
— Enables blink mode.
disable
— Disables blink mode.
Defaults — LED blink mode is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile. Version 6.0 removed the
dap option.
configuration of the MAP configuration profile. Version 6.0 removed the
dap option.
Usage — Changing the LED blink mode does not alter operation of the
MAP access point. Only the behavior of the LEDs is affected.
MAP access point. Only the behavior of the LEDs is affected.
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.