Weber 675 Instruction Manual
7
ADD COOKING MODULE
Figure 7
Figure 8
Caution: Use two people to lift and install the
cooking module.
cooking module.
Lift the cooking module out of the packaging. The gas line
will hang below the module.
will hang below the module.
Lower the module on an angle into the sleeve so the
control panel is under the front top rail. Figure 7. Guide
the gas line through he access hole in the sleeve while
lowering the module.
control panel is under the front top rail. Figure 7. Guide
the gas line through he access hole in the sleeve while
lowering the module.
Lower the back of the cooking module down so it sets on
the rear rail. Figure 8. Be careful not to scratch the paint
of the cooking module when installing the module.
the rear rail. Figure 8. Be careful not to scratch the paint
of the cooking module when installing the module.
The cooking module should be level, setting on the front
and rear rails.
and rear rails.
Front rail
Rear rail
View from
right
View from
right
Flange
Flange
MOUNT REGULATOR
BRACKET
BRACKET
We recommend that you install the regulator to a rigid
structure. The regulator mounting bracket can be used to
mount the regulator to the built-in structure.
structure. The regulator mounting bracket can be used to
mount the regulator to the built-in structure.
The gas line from the manifold is long enough to reach
the mounted regulator. We have provided the means to
make an SAE flare connection. Do not use pipe sealant
on this connection.
the mounted regulator. We have provided the means to
make an SAE flare connection. Do not use pipe sealant
on this connection.
Front
rail